Kawasaki Front mount degree Clip ons

Our clip ons feature a 1in. rise and a zero degree sweep. The 1in rise allows you to run the clip ons below the triple clamp and have the same rise as if they were ran on top. These clip ons are commonly used without an upper, however they can be ran with an upper fairing, but it will have to be trimmed back. One of the benefits of these is you do not have to lower the front of your bike to achieve the rise. Or you can run them on top to achieve a higher rise closer to the feel of dirtbike bars. The handle bar is offset 3/8in out in front of the fork to allow for more adjustability of your handbrake and clutch. One of the benefits of these clip ons is that they make "pull through tricks" easier because it puts your hands further out in front of you. 7/8 x 1/8 wall bar tubes are included. Please note Even though the quantity says 10, this part is currently on Back order and may be up to 2-3 weeks before they will ship out. ********************************************************************************************** Kawasaki [Ninja 250R 37mm] [EX500 94+ 37mm] [EX650R 06-09 41mm] [ZX6R 95-97 41mm] [ZX6R 98-02 46mm] [ZX6R/RR 03/08 50mm] [ZX6R 09 51mm] [ZX7R/RR 91-04 52mm] [ZX9R 94-97 52mm] [ZX9R 98-02 46mm] [ZX10 88-90 41mm] [ZX10R 04-09 50mm] [ZX11 90-97 43mm] [ZRX/1200 46mm] [ZX14R All 50mm]